Download free trace engineering inverter repair

Trace engineering inverter repair

Please remember to do a site search for other related documents which may not be shown here.

Look, you go and invest in an RV or buy a Trace Engineering inverter outright and then you find you aren't going to get any service without getting ripped off. Would you be happy?

I ended up with a Trace 4024MC in a bus I bought. Great device when you read the specs and all this American made machine can do. So they stopped making it, that is what they did. And now you will get ripped off when you go to get service. That's the American way now. Cut the biggest piece, not make the pie bigger.

I said "No, I think I'll just take it home," and I did. Then it occurred to me to take the circuit board out which I did, and I hauled it down to this guy I know and showed it to him. "Oh, that won't take much, I'll call you." And he did. He said he found the chip, that he would have it all repaired in a couple days and it would cost me $65. No shit. You see any part of that mother board, any part of that inverter, you can get the parts for if you have an electronics guy, and just fix it unless your board is fried by lightning to toast or something. So he repaired the damaged trace, replaced the chip, I put it all back together and hefted it up on the bulkhead and everything ran like clockwork.

You have trouble with your Trace Engineering Inverter, call me, anytime, Oregon 971-388-7185. The time now is Feb. 9, 2011. If the phone doesn't ring through leave a message, probably means I am in China or in the shower. Flip a coin. Don't get screwed, get it fixed.

Ok, so you invested $3500 or so in your machine not counting in and out time and the service that you get is to be told that you can only get help if you agree to be ripped off. Yeah great.

My email is: akhalife at gmail.com I answer all email.

Trace engineering inverter repair

This Is One We Use At GetOffTheGrid.com For Over 4 Years And It Has Worked Perfect.

Premium Power, Premium Efficiency , Premium Inverter

The SW4024 SineWave and Have Never Had A Glitch.

Problem: Some inverters simply cannot supply power clean enough for equipment like clocks, timers, laser printers, photocopiers, bread makers and pellet stoves. And modified sine wave inverters sometimes cause "noise" on radios or tv sets.

Solution: The Trace SW-series, the world's best and most advanced inverter.

  • New design makes it easy to use. With separate use and setup menus, new backlit display, improved wiring access and greater generator compatibility.
  • Advanced engineering boosts efficiency . The SW is over 90% efficient through most of its load range, peaking at 96% efficiency. There's negligible idle current.
  • Smart features make it more reliable. New soft start system allows inverter to run heavier loads with improved reliability.
  • Intelligence eliminates guesswork. Brainy Trace SW inverters can be programmed to perform a multitude of tasks like automatic generator start and stop, automatic load sensing, and generator support.
  • Protective circuitry guards against downtime. Including over-current, short circuit, over temperature, low battery and high battery conditions.
  • Feed-back ability makes you a power broker. When connected to a renewable energy system, The SW can feed excess energy back to the utility grid.
  • Charger keeps your batteries happy. All Trace SW inverters include a built-in, fully automatic, three-stage battery charger. It's designed for maximum charging while using minimum generator time and fuel.
  • Outputs match any need. The SW comes in 2.5 kw /12 volt output to 5.5 kw/48 volt models. Most popular models: 4 kw, 24 and 48 volt inverters.

    Stacking offers power to spare. Stack the SW in series for 120/240 VAC output and increased total capacity. With a surge rating 2.5 times greater than their continuous power rating, there is almost nothing that will not start and run on one (or two) of these inverters. (Export models are not stackable, including 230 VAC 50 Hz, 105 VAC 50 Hz 105 VAC 60 Hz.)

    SW Series II Specifications

    4.0 kva - 24 vdc input, 120 vac 60 hz output with 120 amp charger and a 60 amp AC transfer relay

    Retail Cost $3410.00 Sale $ CALL

    5.5 kva - 48 vdc input, 120 vac 60 hz output with 70 amp charger and 60 amp AC transfer relay

    Retail Cost $3970.00 Sale $ CALL

    2.5 kva - 12 vdc input, 120 vac 60 hz output with 150 amp charger and 60 amp AC transfer relay

    Retail Cost $2585.00 Sale $ CALL

    Nominal DC InputVoltage

    AC Output Voltage (RMS)

    Continuous Power @ 25°C

    Continuous AC Output (@ 25 °C)

    Maximum AC Output (RMS)

    Automatic AC Transfer Relay

    Maximum Charging Rate

    DC Input Requirements

    On Mode (no load - idle)

    At Full Rated Power

    Short Circuit Output

    Nominal DC Input Voltage Range

    AC Output Characteristics

    AC Output Waveform

    Sine wave, 34 to 52 steps per cycle

    Total Harmonic Distortion

    3 to 5% (stand alone operation)

    Power Factor Allowed

    +/- 0.04% (crystal regulated)

    Load Sensing Range

    16 to 240 Watts

    Remote Control Panel (50 ft. max.)

    Stacking Interface for double power

    (*requires two inverters)

    DC Disconnect Breaker

    DC Battery / Inverter Cables

    Indoor, ventilated, steel chassis with powdercoat finish

    Specified Temp Range

    32°F to 104°F (0°C to +40°C) (output will meet specified regulation tolerances)

    Allowed Temp Range

    Dimensions - Inverter Only

    15" (38 cm) high, 22.5" (57 cm) wide, 9" (23 cm) deep (wall mounted)

    20.5"(52 cm),27"(69 cm),15.5"(40 cm)

    Wall or Shelf Mount

    Weight - Inverter Only

    Specifications are Provided by Trace Enginnering

Trace engineering inverter repair

Trace Engineering Ltd. is a Toronto based Mechanical and Electrical Consulting Engineering firm. Founded in 2006 we specialize in high/low rise residential, retirement/long term care, commercial, industrial and tenant design areas.

In September of 2015, Trace Engineering Ltd. expanded its retrofit division under the name of "Trace Consulting Group Ltd."

Trace Consulting Group Ltd. concentrates on retrofit applications for both Mechanical and Electrical disciplines.

We provide a high level of service and expertise. Our principals are actively involved in all projects from initial design to final occupancy, providing the utmost service to all clients.

Our services include

  • Heating, Ventilation and Air Conditioning
  • Plumbing and Drainage
  • Fire Protection
  • Lighting
  • Power
  • Secondary Distribution
  • Communication and Security Systems

Trace Engineering & Trace Consulting are certified with the Professional Engineers of Ontario and are LEED® accredited.

Trace Engineering RV Inverter

Trace Engineering RV Inverter

Recent Repairs

Onan Overspeed/Start Disconnect Module 0300-4324

This module is mounted on the bell cover, it reads the RPM of the generator shaft and will disconnect the starter at about 660 RPM and if the generator goes overspeed it will shutdown around 2190RPM (or for 50HZ operation 1830RPM).

We have reproduced these and they are for sale brand new. These aren't pulls or repairs they were built in 2017 by J.R. Electronics on brand new printed circuit boards. The OEM boards failed because of a part that deteriorates with age and heat so beware of buying a pull, it may be on it's last leg. We give one full year warranty on these boards.

We are also willing to repair your unit or to swap a new unit for an inop unit to speed your repair cycle. Call us.